Instruction Manual

PowerOptimal Elon® 100 Installation Manual
Version date: 2022/05/23
Page 4 of 37
Version number: 2.20
© PowerOptimal (Pty) Ltd 2022. The content of this document is confidential and all rights to the intellectual
property and/or information contained herein remain vested in PowerOptimal, except if otherwise agreed in
writing.
1. Required tools
The following tools are required for the installation. Use insulated tools wherever applicable.
• Solar modules (mounting) - please refer to solar module / mounting installation instructions –
the below is only a guideline:
o Cordless screwdriver with bits
o Drill
o Set of drill bits (wood, steel, stone)
o Set of screwdrivers
o Set of Allen (hex) keys
o Tape measure
o Grinder (tile roof installations)
o Permanent marker
o Chalk
o Hammer
• Solar modules (electrical):
o AC/DC Clamp meter
o Side-cutting pliers
o Screwdriver set
o Crimping tool
o 4 mm² wire (double insulated) (or other size as determined by solar PV voltage and
wire length)
o Cable ties
• Elon® 100 - the following additional tools:
o Drill or punch (to make holes for glands)
o 2.5 mm² panel wire