Instruction Manual

property and/or information contained herein remain vested in PowerOptimal, except if otherwise agreed in

writing.

SAFETY WARNING

• Installation of the Elon® 100 should ONLY be performed by an electrical

contractor registered with the Department of Labour (the so-called

“wireman’s licence”) and strictly according to the installation instructions

in this manual. The electrician should provide you with a Certificate of

Compliance (CoC) once installation is completed.

• We strongly recommend that you use a reputable and experienced solar

photovoltaic (PV) system installer to install your solar PV modules.

• Solar PV modules exposed to the sun are live (i.e. will produce electricity)

and can give an electric shock. Special care should be taken and only

trained solar PV installers should install the modules.

• Do not attempt to alter or service the electrical installation, or open the

Elon® 100 unit or controller for any purpose.

• Use the Elon® 100 only for its intended purpose.

• Always make sure that every wiring connection is properly tightened.

• Do not earth either of the solar module wires (but do earth the frames).

• All installation wiring should be at least 2.5mm².

• Avoid coiling, since DC switching can create damaging spikes.

• Keep all wires as short as possible.

Refer to the PowerOptimal website for the following:

Elon® 100 User

Manual

www.poweroptimal.com/manuals

Training videos for

electricians

www.poweroptimal.com/elon-100-training

Online User

Instructions Video

www.poweroptimal.com/elon100

Online Elon® Basic

Training Course

https://moolmaninstitute.com/p/elon-course