Use and Care Manual

Important Safety Information (CONTINUED)

• Save all instructions

Fuel Safety

WARNING

• Gasoline is extremely flammable and gasoline vapors can explode if ignited. Handle with care.

• Use an approved container.

• Check fuel supply before each use, allowing space for expansion as the heat of the engine and/or sun can cause

fuel to expand.

• Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors.

• Never remove gas cap or add fuel with the engine running. Allow engine to cool before refueling.

• Do not smoke while refueling.

• After refueling, replace fuel tank cap securely and wipe up spilled fuel.

Storage Safety

• Always refer to the operator’s manual instructions for important details if the Edger is to be stored for an

extended period.

• Never store the Edger with fuel in the fuel tank inside a building where ignition sources are present such as water

heaters, space heaters, clothes dryers, etc.

• To reduce fire hazard, keep Edger free of grass, leaves or other debris build-up

• Allow the engine to cool before storing in any enclosure.

Repair, Maintenance, and Adjustment Safety

• After striking a foreign object, stop the engine. Remove the wire from the spark plug and keep the wire away from

the plug to prevent accidental starting. Thoroughly inspect the Edger for any damage. If damaged, have the

equipment repaired by a trained technician before restarting and operating.

WARNING

• Stop the engine before cleaning, repairing or inspecting the unit. Make sure all moving parts have stopped. Let the

engine cool, disconnect the spark plug wire and move it away from the spark plug.

• Never attempt to make any adjustments while the engine is running except when specifically recommended by

the manufacturer.

• Keep the Edger in a safe working condition. Check all fasteners at frequent intervals for proper tightness.

• When servicing or repairing the Edger, do not tip the machine over or up unless specifically instructed to do so in

this manual. Service and repair procedures can be done with the Edger in an upright position. Some procedures will

be easier if the machine is lifted on a raised platform or working surface.

• Use only original equipment or authorized replacement parts.

• Never tamper with safety devices. Check their proper operation regularly.

• Do not change the engine governor setting or over-speed engine.

• Clean and replace safety and instruction decals as necessary.

• To guard against engine over-heating, always have engine debris filter mounted and clean.

Children Safety

WARNING

• Tragic accidents can occur if the operator is not alert to the presence of children.

• Keep children out of the edging area and under the watchful care of a responsible adult.

• Never assume that children will remain where you last saw them.

• Be alert and turn Edger off if children enter the area.

• Before and while moving backwards, be aware of small children.

• Never allow children to operate the Edger.

• Use extra care when operating near blind corners, shrubs, trees, or other objects that may obstruct vision.