Use and Care Manual

ManualsBrandsPowermate ManualsOutdoor Power Combo Kits43cc Wheeled String Trimmer with Edger Attachment and Blower Attachment Combo Kit

Assembly (Continued)

• Save all instructions

Wheel Assembly:

String Storage:

1. Install the right wheel to the frame using the longer

shoulder screw and spacer. Tighten to 25 ft. lbs.

(34 N.m) torque using a 14 mm wrench. (Fig. 9-10)

2. Install the left wheel to the adjuster assembly stud

using the shorter shoulder screw. Tighten to 25 ft. lbs.

(34 N.m) torque. (Fig. 11 & 12)

3. Move the bevel handle to the low position for

level mowing.

1. Snap the lower tube clip onto the left middle handle

using the pierced hole. (Fig. 12)

2. Snap the upper tube clip onto the left middle handle

above using the pierced hole.

3. Install the clear tube with provided extra string

into the clips. (Fig. 13)

Fig. 12

TUBE CLIP

Fig. 13

UPPER

CLIP

TOP CAP

LOWER

CLIP

Debris Guard:

1. Insert the tab on the metal mounting bracket into the

slot on the debris guard.

(Fig. 5-6)

2. Install the hex head cap screw through the bracket

and into the metal insert of the debris guard.

Tighten securely using a 10 mm wrench.

(Fig. 7-8)

The trimmer line knife attached to the debris guard is

sharp and can cut you. Handle with care.

CAUTION

SLOT FOR

BRACKET TAB

DEBRIS

GUARD

HEX HEAD

CAP SCREW

HEX HEAD

CAP SCREW

METAL MOUNTING

BRACKET

METAL MOUNTING

BRACKET

Fig. 5

Fig. 7

Fig. 6

Fig. 8

SPACER

Fig. 9

Fig. 11

Fig. 10

Fig. 12

SHOULDER

SCREW

(SHORTER)

BEVEL

HANDLE

SHOULDER

SCREW

ADJUSTER

ASSEMBLY