Product Manual

General Information and Setup
Owner’s Manual for Power Washer 3
Section 2 General Information and Setup
Know Your Power Washer
Read this manual thoroughly before
assembling and operating this unit. Save this
manual for future and immediate reference.
Replacement owner’s manuals are available
at www.powermate.com.
Emissions
The United States Environmental Protection
Agency (US EPA) (and California Air
Resources Board (CARB), for engines/equip-
ment certified to California standards) requires
that this engine/equipment complies with
exhaust and evaporative emissions stan-
dards. Locate the emissions compliance decal
on the engine to determine applicable stan-
dards. For emissions warranty information,
please reference the included emissions war-
ranty. It is important to follow the maintenance
specifications in the manual to ensure that the
engine complies with the applicable emissions
standards for the duration of the product’s life.
Remove Contents from Carton
1. Open carton completely by cutting each
corner from top to bottom.
2. Remove and verify carton contents prior to
assembly. Carton contents should contain
one each of the following:
•Main Unit
• Handle Assembly
• High-pressure Hose
• Spray Gun
•Lance
•Oil
• Gun Hook Wireform, Lower Gun Rest
and Hardware
• Parts Bag (includes):
– Owner’s Manual
– Bag of Colored Nozzles
– Register your product at https://reg-
ister.generac.com/
3. Call Powermate Customer Service at 1-
800-445-1805 with the unit model and
serial number for any missing carton
contents.
4. Record model, serial number, and date of
purchase on front cover of this manual.
Assembly
Call Powermate Customer Service at 1-800-
445-1805 for any assembly issues or
concerns. Please have model and serial
number available.
The following tools are required for assembly.
• Screw Driver
• 10mm Wrench
• 13mm Wrench
See Figure 2-1. Place handle (A) onto handle
supports (B). Push in latch buttons (C) and
allow handle to slide into position. Button will
lock handle into place.
Figure 2-1. Insert Handle
NOTE: It may be necessary to move the
handle supports from side to side in order to
align the handle so it will slide over the handle
supports.
See Figure 2-2. Install spray gun holster and
secure with lock nuts (2) and 10mm wrench.
Figure 2-2. Install Spray Gun Holster
See Figure 2-3. Install bottom gun rest (A) and
secure with bolt, lock nut and 10mm wrench.
(000100a)
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
(000100a)
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
001617
A
B
C
005606