Owners manual

39
N.O.
CONTACT
Four Wire
Radio Reciever
Wired For
"OPEN/CLOSE"
Four Wire Radio Reciever
Wired For "OPEN" Only
NOTE: Must Be Used With
Timer to Close Option.
GY
BK
GY
R
GY
BK
GY
R
COM COM COM 24V
AC
24V
AC
ALT
RDO OPN CRO FRE OPN CLO STO COM
STOP
PUSH
CLOSE
PHOTO
OP EN
PHOTO
LD1 6
LD1 7
LD1 3
FORCE
ADJUSTMENT
TB1
U4
COM COM COM 24V
AC
24V
AC
ALT
RDO OPN CRO FRE OPN CLO STO COM
STOP
PUSH
CLOSE
PHOTO
OPEN
PHOTO
LD1 6
LD1 7
LD1 3
FORCE
ADJUSTMENT
TB1
U4
24 VAC
N.O.
CONTACT
24 VAC
CONNECTIONS FOR
OPEN/CLOSE OPERATION
CONNECTIONS FOR
OPEN ONLY OPERATION
1. For electrical connections of a four-wire radio receiver
via the external terminal strip. See below.
NOTE
: Internal wiring for the radio control terminal strip is
factory set-up for the OPEN ONLY option. For the
OPEN/CLOSE option, move the wire on the control board
terminal strip from the “RDO OPN” terminal to the ‘CRO”
terminal.
RADIO
R1
R2
R3
GY
R
BK
GY
R4
N.O.
CONTACT
RADIO CONTROL
TERMINAL
24 VAC
40
LOOP DETECTOR SYSTEMS AND INSTALLATION
The diagram below depicts the typical loop options for a
Slide Gate installation.
1. The Exit Loop provides a signal to open the gate
when a vehicle enters the loop zone.
2. The Reversing Loops protect a vehicle in the
loop zone from being contacted with the gate by
overriding any close signal while the gate is
open, and by reversing the gate if closing.
4'
4'
4'
4'
4'
4'
4'
4'
Road Surface
Sealant
Loop wires
Min 1"
3/16" To 1/4"
Saw Slot