Owner's manual

POWERMADD
®
Yamaha Throttle Extension Kit
Installation Instructions for Part No. 13595
TOOLS REQUIRED: HARDWARE INCLUDED:
Pliers Item
Qty Description
No. 1 Phillips Screw Driver 1 2 Junction Box Halves
8mm Wrench 2 1 Junction Slide
10mm Wrench 3 4 Self-Threading Screws
4 3 Retaining Clips (1 Extra)
5 1 Cable
6 1 Low-Temp Grease Pack
WARNING: Read all instructions before installing Extension Kit. Snowmobile should not be
running while installing or making any adjustments to the Extension Kit.
PowerMadd also recommends using a tether cord for the safest operation of your
snowmobile. If at anytime you suspect there is a problem with the throttle
controls, immediately shut off snowmobile and inspect. If you are experiencing
problems with our Extension Kit, contact PowerMadd for customer service.
Step 1: Be sure carburetor(s) are correctly in sync and
set up. If snowmobile is not running properly
before installing Extension Kit, the
snowmobile will not run correctly after
installing Extension Kit.
Step 2: Unhook the stock throttle cable from the
throttle lever using a small screw driver and a
needle nose pliers. Be careful not to damage
the braided cable.
Step 3: Remove the two Phillips screws which hold the
throttle block assembly together. See Figure
POWERMADD
®
1-800-435-6881
www.powermadd.com
PP5069 REV A
1.
Step 4:
le cover from the throttle block.
See Figure 2.
Step 5:
cable clip and remove the clip. See Figure 3.
Step 6:
he
extension cable. Refer to Illustration A.
Remove the three Phillips screws to disconnect
the throttle cab
Remove the Phillips screw holding the throttle
Install one of the retaining clips from the kit on
the stock cable, and one on the ball end of t

Summary of content (2 pages)