Owner's Manual

PGM200X

STEP 2

BE CAREFUL TO ASSEMBLE ALL COMPONENTS

IN THE SEQUENCE THAT THEY ARE PRESENTED.

NOTE:

finger tighten all hardware in this step. DO NOT wrench tighten

until the last step. some components may be pre-assembled.

nylon lock nuts will not fully screw onto bolts, must wrench tighten.

2A. attach vertical frame (E) to mainframe (A) using:

2 - (#30) M10X55mm hex head bolt

4 - (#50) M10 washer

2 - (#40) M10 nylon lock nut

note: adjust hole position as necessary to accomodate

your personal body height.

2B. insert a square end cap into the front and rear opening

of adjust frame (F) using:

2 - (#5) 25X50mm square end cap

2C. attach chest pad (M) to adjust frame (F) using:

2 - (#32) M8X40mm hex head bolt

2 - (#54) M10 spring washer

2 - (#51) M8 washer

2D. slide adjust frame (F) into vertical frame (E) and fix

the position using pop pin (#20).

2E. attach leg pad (L) to mainframe (A) using:

4 - (#33) M8X20mm hex head bolt

4 - (#54) M10 spring washer

4 - (#51) M8 washer