Owner's Manual And Operations Guide

Removing Stumps
❏ Remove all loose pieces of wood, stones, wire and other debris from the area
before beginning stump removal.
❏ Wind direction should be considered, as it will influence the direction in which
dust and wood chips are directed.
❏ Never operate the grinder after dark. There will be no adequate light for the
operator to use the grinder safely.
❏ Always allow a cold engine time to warm up before cutting a stump.
❏ Only the portion of cutting wheel within the 80 degree area shown below
should engage the stump. Never undercut the stump or use the bottom of
the cutting wheel for cutting purposes.
❏ Never leave controls when the cutting wheel is rotating.
❏ Do not angle engine more than 25 degrees while in operation. Doing so can
cause damage to the engine.
Stump Grinder 8
QVTOOLS, LLC | 2731 CRIMSON CANTON DRIVE, LAS VEGAS, NV 89128 | 1-800-344-3371