Owner's Manual And Operations Guide

OPERATIONS
Adding Oil To The Engine
1. Only fill the fuel tank to a level 15mm lower than the top of the fuel tank. Do
not overfill.
2. Use the dipstick to check the oil level. Use 10w-30 / 10w-40 / 15w-40
non-synthetic engine oil. Fill to the correct level before use.
NOTE: The engine is shipped without oil. Operating the engine with no oil or oil at a
low level will destroy the engine. This is not covered under warranty.
Starting The Engine
❏ Lock the travel wheel by pulling the brake lever back fully.
❏ Make sure throttle is in slow position.
Do not allow the rope to snap back. Set it back by hand to prevent damage to the
starter.
❏ If the engine is cold, move the choke lever to the closed position.
❏ Raise the cutter wheel 4 to 5 inches off the ground by pushing downwards on
the handle bar and hold it in that position.
This next step may cause the cutter wheel to rotate. Keep everyone away.
❏ Pull the starter rope lightly until you feel resistance, then pull briskly.
❏ Move the choke lever to the open position.
The next step causes the cutter wheel to rotate. Again, keep everyone away.
❏ Move the throttle to fast. If the engine is cold, allow the engine to idle
(throttle set to slow) for a few minutes before cutting.
Stump Grinder 7
QVTOOLS, LLC | 2731 CRIMSON CANTON DRIVE, LAS VEGAS, NV 89128 | 1-800-344-3371