Product Manual

Page 16 of 27
Install Discharge Chute to Power Unit
Place the housing body (D) on a flat surface and keep it stable.
Install the discharge chute (E) to the housing by attaching the knob (A) through the spring washer (B)
and the flat washer (C). See figure 2. The chute’s opening direction can be adjusted during installation
per the operation’s needs.
Install the direction plate (F) with the chute with a screw nut and a bolt. The knob can be used to
adjust the discharge direction without a tool. See figure 3.
Installing the Hose and Boom Arm to Housing (figure 4)
1. Remove hose (A) from the box and stretch it.
2. Hold the hose and stretch each end as far as possible to open internal diameter.
2. Install the adapter (B) with the housing (E) by tightening the screw nut.
3. Insert one hose end with the hose adapter (B) by tightening the hose clamp (C).
4. Place the hose bands (G) over the hose.
5. Place the boom arm (F) pivot shaft into the housing tube.
6. Install the hose nozzle (D) and handle assembly onto other end of the hose. Adjust the handle to
the desired position and tighten the clamp.