Product Manual

Page 7 of 27
⚠CAUTION
TRUCK LOADER VAC USE AND CARE
 Do not force the truck loader vac. Products are safer and do a better job when used in the
manner for which they are designed. Plan your work, and use the correct product for the job.
 Check for damaged parts before each use. Carefully check that the product will operate properly
and perform its intended function. Replace damaged or worn parts immediately. Never operate
the product with a damaged part.
 Do not use a product with a malfunctioning switch. Any power tool that cannot be controlled with
the power switch is dangerous and must be repaired by an authorized service representative
before using.
 Disconnect the power/air supply from the product and place the switch in the locked or off
position before making any adjustments, changing accessories, or storing the tool. Such
preventive safety measures reduce the risk of starting the tool accidentally.
 Store the product when it is not in use. Store it in a dry, secure place out of the reach of children.
Inspect the tool for good working condition prior to storage and before re-use.
 Use only accessories that are recommended by the manufacturer for use with your product.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure
than the tool itself.
 Keep guards in place and in working order. Never operate the product without the guards in
place.
 Do not leave the tool running unattended.
Specific Operation Warnings
⚠WARNING
 READ THIS ENTIRE MANUAL AND MOTOR MANUAL: These manuals contain proper
operating and safety instructions for this chipper/ shredder.
 SAFETY EQUIPMENT: Wear safety glasses, hearing protection, and gloves when operating a
Chipper Shredder. Make sure any bystanders are also wearing safety equipment.
 ENGINE OPERATION: Refer to the engine manual for operating instructions and gasoline
engine safety warnings.
 HAND SAFETY: DO NOT put hands or other body parts into the inlet or outlet while the blades
are turning. The truck loader can drag you into the blade, causing amputation of fingers, hands
or other body parts. DO NOT touch the exhaust during or immediately after operation to prevent
burns.
 CLOTHING: DO NOT wear loose clothing, neckties, scarves, or jewelry which may get caught in
moving parts. DO NOT wear clothing or gloves with pull ties or straps. This type of clothing could
get tangled with material that is being shredded, pulling you into the truck loader.
 OPERATING LOCATION: Set up the truck loader a on firm, level, grass or dirt. DO NOT set up
the truck loader on gravel, asphalt, concrete, or stone. The chips are expelled from the machine