Product Manual

Page 16 of 27
Installing the Discharge Chute to the Power Unit
Place the housing body (D) on a flat surface to keep it stable.
Install the discharge chute (E) to the housing by attaching Knob (A) through the spring washer (B) and
Flat Washer (C). See figure 2. The chute’s open direction can be adjusted during installation
depending on the operation’s needs.
Install the direction plate (F) to the chute with a screw nut and bolt. The knob can be used to adjust
the discharge direction without a tool. See figure 3.
Installing the Hose and Boom Arm to the Housing (see figure 4 for assembly)
1. Remove hose (A) from the box and stretch it.
2. Hold the hose, and stretch each end as far as possible to open the internal diameter.
2. Install the adapter (B) with the housing (E) by tightening the screw nut.
3. Insert one hose end with the hose adapter (B) by tightening the hose clamp (C).