Product Manual

Installation / Initial Set-Up (cont’d)

There are a number of important steps required to set up your generator for initial use. These steps are:

Steps for Installation / Initial Set-Up

1. Unpacking & delivery inspection.

2. Planning the power load to stay within the generator’s rated capacity.

3. Setting up generator for the type of power generation you need:

a. portable power source, or

b. connect to a building as a back-up power source.

4. Selecting a site for using the generator.

5. Grounding the generator.

6. Battery installation (electric start models only).

7. Wheel kit assembly.

Each of these steps is discussed in detail below:

1. Unpacking & Delivery Inspection

You should inspect the generator immediately after you receive delivery.

See the “Machine Component Identification” section of this manual for a diagram of the generator and

its components.

 If you are missing or have damaged components, contact Product Support at 1-866-443-2576.

Assembly Parts and Fasteners:

Vibration Bracket

Qty 2

Rubber Feet

Qty 2

Funnel

Qty 1

Axle Washer

Qty 2

Cotter Pin

Qty 2

Axle Clamp

Qty 1

Axle

Qty 1

Spark Plug Wrench

Qty 1

Screw Driver

Qty 1

Wheel Assembly

Qty 2

M8x16 Bolt (Large)

Qty 8

M8x16 Bolt (Small)

Qty 4

M8 Flange Nut

Qty 10