Product Manual

Page 7866-443-2576
OPERATOR INSTRUCTIONS AND PARTS
Prevention of Burns and Fires
 
 
hot and will cause severe burns.
 
operation.
 

This engine is designed to operate using a catalytic
converter which contributes to the engine’s compliance
with the EPA.
Steps for Working on Engine or Cultivator
1. Turn off engine switch.
2. Disconnect the spark plug wire from the spark plug.
3. Securely place the disconnected spark plug wire
away from the spark plug and any metal parts. This
must always be done or arcing may occur between
spark plug wire and metal parts.
4. Replace or repair the part on the engine or cultivator.
5. Check all parts that were repaired, or removed during

NOTE: All repair parts must come from the factory.
Never replace parts that are not specically designed
for the engine or cultivator.
6. Replace spark plug wire.
CAUTION
HOT GASES ARE A NORMAL BY-PRODUCT OF A
FUNCTIONING CATALYTIC CONVERTER. FOLLOW
ALL SAFETY INSTRUCTIONS TO PREVENT BURNS
AND FIRES.
DO NOT ALTER/MODIFY ENGINE:
NEVER ALTER OR MODIFY THE ENGINE FROM THE
FACTORY. SERIOUS INJURY OR DEATH MAY OCCUR
IF ENGINE IS MODIFIED OR ALTERED.
WHEN WORKING ON OR REPLACING PARTS FOR
THE ENGINE OR CULTIVATOR YOU MUST ALWAYS
DISCONNECT SPARK PLUG WIRE FROM THE SPARK
PLUG AND KEEP IT AWAY FROM THE SPARK PLUG.