Product Manual
Page 16
OPERATOR INSTRUCTIONS AND PARTS
866-443-2576
Cooling Fins
debris before each use.
Air Filter
Never run engine without air cleaner properly installed.
Added wear and engine failure may occur if air cleaner is
not installed on engine.
Service air cleaner every 3 months or after 20 hours of op-
eration. Clean lter daily in extremely dusty conditions.
Steps for Cleaning Air Filter (Ring Style Foam Filter)
- See parts explosion on page 26.
1. Wash in warm water with liquid detergent and water until
do not twist.
2. Rinse in warm water until soap and dirt are removed.
until it is dry.
4. Apply a lightweight motor oil or thin based machine oil
5. Remove excess oil.
.
IMPORTANT
NEVER TWIST AIR FILTERS WHEN CLEANING.
ALWAYS PRESS.
Steps for Cleaning Air Filter (Block Style Foam Filter)
- See parts explosion on page 26.
lever to the choke position. (Figure 1)
both sides of the cover. (Figure 2)
cover by rotating the cover away from the engine.
(Figure 3)
(Figure 4) and re-
previous steps for Cleaning Air Filter. Remember to
-
tor oil and squeeze out any excess oil.
to ensure that the foam is fully seated into its sealed
position. (Figure 5)
place and is secured by the latch tabs. Check that the
cover is securely attached by pulling slightly on the cov-
er. If the cover doesn’t move when pulled, it is secure.
Figure 1
Figure 3
Figure 5
Figure 2
Figure 4