Product Manual

Machine Component Identification
15
Low Oil Warning
Light
When the oil level falls below the lower level, the oil warning light 1 comes
on and the engine stops automatically. The engine will not start again until
oil has been added.
Note: If the engine stalls or does not start, turn the engine switch to “ON”
and then pull the recoil starter. If the oil warning light flickers for a few
seconds, the engine oil is insufficient. Add oil and restart.
Overload Indicator
Light (Red)
The overload indicator light 1 comes on when an overload of a connected
electrical device is detected, the inverter control unit overheats, or the AC
output voltage rises. The AC protector will trip, stopping power generation
in order to protect the generator and any connected electric devices. The
output indicator light (green) will go off and the overload indicator light
(red) will stay on but the engine does not stop running. When the overload
indicator light comes on and power generation stops, proceed as follows:
1) Turn off any connected electric devices and stop the engine.
2) Reduce the total wattage of connected electric devices within the
rated output.
3) Check for blockages in the cooling air inlet and around the control
unit. If any blockages are found remove.
4) After checking, restart the engine.
Note: The overload indicator light may come on for a few seconds at first
when using electric devices that require a large starting current, such as a
compressor or a submersible pump. However, this is not a malfunction.
Output Indicator
Light (Green)
The Output Indicator Light 1 comes on when the engine starts and
produces power.