Product Manual

Assembly Instructions

Step 20 - Fittings

• Screw finger-tight (1) Return Line Fitting into the return line filter head

• Wrench-tighten the fitting to 1.5-3.0 turns past “finger tight” position. Consider

final orientation position as to not exceed the recommended TPFT. Properly

assembled fittings total thread engagement should be 3.5-6 turns

• CAUTION: Never back off an installed pipe fitting to achieve proper alignment.

Loosening installed pipe fittings will corrupt the seal and contribute to leakage

and failure.

• Connect the end of the suction hose to the pump inlet.

• Secure the low pressure return hose to return line fitting with supplied hose

clamp installed on hose. Torque to 77 in.-lb.

Tools Needed

• Flat Blade Screw

Driver

• Crescent Wrench

• 1 1/16” Wrench

Fasteners Needed from Parts Bag:

Return Line Fitting

Qty: 1

1 3/8” Wrench

Return Line

Filter Head

Return

Line

Fitting

Suction Hose

Hose Clamp

Pump Inlet