Product Manual

54
Assembly Instructions
Step 16 -Fittings
• Lubricate O-ring and threads on fitting with clean oil
• Orientate (1) Valve Fitting so that nut/washer/O-ring assembly is facing up.
Turn fitting into cylinder port until finger-tight
• Torque to 37-46 ft.-lb.
• Looking at fitting from end with nut/washer O-ring assembly, turn nut
clockwise as far as possible
• Use valve port marked “A “ to thread the control valve onto the fitting until
control valve touches washer
• Hold control valve in orientation shown below and torque nut to 37-46 ft.-lb.
Tools Needed
• 7/8” Wrench
(2 needed)
OR
• Crescent Wrench
(2 needed)
Fastener Needed from Parts Bag:
Valve Fitting
Qty: 1
Into
Cylinder
Nut
Washer
O-Ring
Valve Fitting
Cylinder Port
Valve Port