Product Manual

43
Assembly Instructions
Step 5 – Tank Weldment
• Screw finger-tight (1) Return Line Filter Head onto hydraulic tank return port.
NOTE: the arrow on filter head should point towards the tank.
• Wrench-tighten the fitting to 1.5-3.0 turns past “finger tight” position. Consider
final orientation position as to not exceed the recommended TPFT. Properly
assembled fittings total thread engagement should be 3.5-6 turns.
• CAUTION: Never back off an installed pipe fitting to achieve proper alignment.
Loosening installed pipe fittings will corrupt the seal and contribute to leakage
and failure.
• Screw finger-tight (1) Return Line Filter Canister onto bottom of return line
filter head until gasket makes contact. Tighten filter an additional 1/2 turn.
Tools Needed
• Pipe Wrench
OR
• Crescent Wrench
Return Line
Filter Canister
Qty: 1
Return Line Filter
Head
Return Line
Filter Canister
Hydraulic Tank
Return Port
Parts Needed from Manual Bag:
Return Line Filter
Head
Qty: 1