Product Manual A

Page 22 of 28
Replacing V-Belt
Replace or tighten the V-belt if you notice the motor running and the chipper blades are not spinning.
1. TURN OFF THE MACHINE, ALLOW ALL MOVING PARTS TO COME TO A COMPLETE STOP,
AND DISCONNECT THE SPARK PLUG WIRE!
2. Remove the V-belt cover as shown in Pic.22.
3. Roll the belt off of the pulleys and install the new belt.
4. Replace the V-belt cover and re-attach the spark plug wire.
Storage
Follow these guidelines when storing your Chipper Shredder.
 Remove the spark plug wire to prevent unauthorized starting.
 Empty the bag before storing to keep the mulch from rotting in the bag.
 Place the Chipper Shredder in a dry, level area. If the unit is tipped it may leak oil and gas.
 DO NOT store the Chipper Shredder near an ignition source, such as a wood stove, gas or
electric heater, or an appliance or heater with a pilot light.
 Store the Chipper Shredder in a well ventilated area. DO NOT store the Chipper Shredder in an
area that will allow toxic gas fumes into areas inhabited by humans or animals.
 Close the discharge chute deflector and place the covers over the hopper and the funnel to
prevent objects or critters from getting into the machine.
If the engine is not to be used, or is to be stored for more than one month, the following storage
procedures should be carried out.
1. Drain all the fuel from the fuel tank and the carburetor. Ensure that all the fuel has been removed.
2. Remove the spark plug and pour approximately one tablespoon of clean engine oil into the spark
plug hole.
3. With the ignition turned OFF, gently pull on the recoil starter cord several times.
4. Re-fit the spark plug continue to pull the recoil starter cord until the piston is on the compression
stroke (when resistance is felt) then stop pulling.