Quick Start Guide
12
3. Choose the type of Device you have. If you have more than one type
of device you can run the Device Wizard a second and third time later.
4. Click Next.
2.2.2.1 Insteon Devices
For Insteon Devices you have three ways of telling PowerHome2 about those
devices.
a. You can manually add each device. To add the device
manually you have to know the address of each Insteon device.
The address of an insteon device is a 6 digit hexadecimal
number usually found on the front of the device. This method
works well if you only have a few Insteon devices.
b. If you have an existing Insteon setup with a PLC or PLM
controller, PowerHome2 can automatically read the list of
devices from the PLC or PLM by scanning the controller and
then automatically scanning each device for additional
information.
c. For a larger Insteon installation that has not yet been set up,
PowerHome2 can Auto-Discover each device. This requires
you to visit each device and place the device in link mode.
PowerHome2 then scans the device and plays a tune to let you
know it has discovered the device. After taking the device out of