PowerHome2 & Elk M1 Gold Manual

2.2 Defining Elk Inputs and Outputs in PowerHome2
In order for PowerHome to work properly with the above Elk controls, you MUST first use the Elk
RP configuration software to setup each control appropriately. This cannot be done from within
PowerHome since the protocol for this configuration is proprietary and is not made available to
developers. If your Elk is already up and running you have already done this. For a new Elk
installation, or if you adding anything new to an existing Elk installation, first use Elk RP to set up
the control.
2.2.1 From within PowerHome2 go to the PowerHome Explorer and navigate to
PowerHome Explorer|PowerHome|Devices/AnalogIO.
2.2.2 Right click a blank area in the window and click insert to add a blank line.
9