Owner's Manual

If there is any doubt about sizing the battery bank, it is
safe to over estimate the Amp hour requirements of the
battery bank.
Note:
The type of batteries you use to power your high-power
inverter is important. Operating a high-power inverter .
will routinely discharge batteries and they will require
frequent recharging. Batteries used to start engines are
not designed to repeatedly charge and discharge. We
recommend using "deep-cycle" or "marine" rated
batteries.
CABLE GAUGES
When connecting the inverter to a battery bank use the
thickest stranded insulated copper wire available in the
shortest length practical.
Mounting the Inverter
Your inverter should not
be mounted under the
hood of a vehicle. If
installing in a vehicle,
choose a dry, cool,
ventilated area close to
the battery as practical.
Before drilling any
mounting holes, make
sure that there are no
wires, fuel lines, or tanks
directly behind the
surface to be drilled.
To mount the inverter:
LENGTH PDIPS1000B
1ft 8AWG
2ft
8AWG
3ft 8AWG
4ft 6AWG
5ft 4AWG
6ft 2AWG
7ft
2AWG
8ft 2AWG
9ft
2AWG
10ft 2AWG
RECOMMENDED FUSE SIZE
AMPERAGE 100A
1. Inverter ON/OFF switch must be in the OFF position.
2. The inverter should be mounted horizontally.
3. Position the inverter against the mounting surface and
mark locations of the mounting screw openings.
4. Remove the inverter and drill four ( 4) mounting holes.
18