Owner's Manual

NOTE:
• When using an extension cord from the inverter to
an appliance the extension cord should not be longer
than 50 feet.
TELEVISION AND AUDIO SUGGESTIONS
Although all PowerDrive inverters are shielded and
filtered to minimize signal interference with your
television picture may be unavoidable, especially in
weak signal areas.
Here are some suggestions that may improve reception:
1. First, make sure that the television antenna
produces a clear signal under normal operating
conditions. Also, ensure that the antenna cable is
properly shielded and of good quality.
2. Change the positions of the inverter, antenna cables
or TV power cord.
3. Isolate the TV, its power cord and antenna cables
from the 12-volt power source by running an
extension cord from the inverter to the television set.
4. Coil the television power cord and the input cables
running from the 12-volt power source to the inverter.
5. Attach a
11
Ferrite Data Line Filter" to the television
power cord. More than one filter may be required.
These filters are available at most electronic supply
stores.
NOTE:
Some inexpensive audio systems may produce a slight
"buzzing" sound when operated with the inverter. The
only solution to this problem is to use a sound system
with better power supply filtering.