Specifications

CONFIDENTIAL

Installing the MLB

1. Lower the MLB into the chassis at an angle. Lay the board flat and align the mounting holes with the

posts.

2. Replace the eight screws that secure the MLB to the chassis.

3. Reconnect the cables attached to the MLB. Connect the power cable by pressing the retaining

clip facing the front of the computer, then pressing down. Connect all remaining cables to their

connectors.

If the cable does not have a directional connector, then connect it with the label on the cable

connector facing the rear of the computer.

4. Install the RAM (refer to RAM Removal/Installation on page 9).

5. Install the Cache card (refer to Installing the Cache on page 13).

6. Install the CPU (refer to Installing the CPU on page 11).

7. Install the PCI Riser card and assembly (refer to PCI Riser Card Removal/Installation on page 16).

8. Install the Adaptec SCSI card (refer to Adaptec SCSI Card Removal/Installation on page 18).

9. Install the PCI card(s) (refer to PCI Cards Removal/Installation on page 14).

10. Replace the base. The base is retained with two screws on the back in the bottom center of the

computer and one directly on the bottom of the computer. Slide the base toward the front of the

computer to move into place.

11. Reset the CUDA

(refer to CUDA Reset on page 4).

12. Install the chassis cover. (refer to Chassis Cover Removal/Installation on page 6).