Specifications

CONFIDENTIAL

6. Connect the UltraSCSI cable to the Adaptec SCSI card.

7. Reset the CUDA

(refer to CUDA Reset on page 4).

8. Replace the chassis cover (refer to Chassis Cover Removal/Installation on page 6).

Routing the Ultra SCSI Cable

1. Use the fold in the cable to identify the end that attaches to the Adaptec SCSI card. The connector

closest to the fold attaches to the PCI card. The other connector attaches to the card.

2. The Adaptec SCSI card should be in the second or middle slot.

3. Use the 50-pin connector to attach the cable to the Adaptec SCSI card.

4. Guide the cable around the front end of the PCI Riser card.

5. Guide the cable between the back of the floppy disk drive and the CPU card. It is acceptable for the

cable to touch the edge of the heat sink.

6. Attach the end of the cable to the internal hard drive.

5.25-inch Drive