Specifications

CONFIDENTIAL

4. Hold the Adaptec SCSI card (contacts facing down) with one hand at each end. Notice that there is a

notch in the contact edge of the PCI card.

5. Lower the Adaptec SCSI card squarely into the PCI riser card so that the notch in the PCI card lines up

with the notch in the PCI riser card. Slide the contacts straight into the PCI riser card and make sure the

contacts are firmly seated. (

see Figure 13: Adaptec card installation on page 19). When properly

seated, the contacts on the bottom should not be visible. Secure the PCI card to the chassis with the

retaining screw.

DonÕt force the PCI card into the slot; if the PCI riser card starts bending significantly, pull the

PCI card out, reposition it, and try again.

Slot cover screw

PCI slot cover

PCI slot

Figure 12: Removing PCI

slot cover

Figure 13: Adaptec

card installation

PCI card

Slot cover screw