Specifications

CONFIDENTIAL

Installing the MLB

1. Slide the MLB into the chassis from the bottom. Lay the board flat and align the mounting holes with

the posts.

2. Replace the eight screws that secure the MLB to the chassis.

3. Reconnect the cables attached to the MLB. Connect the power cable by pressing the retaining

clip facing the front of the computer, then pressing down. Connect all remaining cables to their

connectors.

If the cable does not have a directional connector, then connect it with the label on the cable

connector facing the rear of the computer.

4. Install the RAM (refer to RAM Removal/Installation on page 10).

5. Install the PCI Riser card (refer to PCI Riser Card Removal/Installation on page 18).

6. Install the PCI card(s) (refer to Installing PCI Cards on page 15).

7. Install the Cache card (refer to Installing the Cache on page 14).

8. Install the CPU (refer to Installing the CPU on page 12).

9. Reset the CUDA (refer to CUDA Reset on page 4).

10. Install the chassis cover. (refer to Chassis Cover Removal/Installation on page 6).