Specifications

CONFIDENTIAL

Installing the Floppy Disk Drive

1. Slide the drive into the bay and align the holes in the drive with the holes in the bay.

2. Insert two screws on each side of the bay to secure the drive to the bay. The floppy disk drive should

protrude about 1.5-inches past the front of the chassis in order to be flush against the front bezel when

it is installed.

3. Slide the bay in at a 45¼ angle making sure that the floppy disk drive is properly aligned with the

opening on the front of the chassis. Once the floppy disk drive is aligned, push the bay toward the top

of the 5.25-inch drive bay.

With the floppy disk drive bay resting against the 5.25-inch bay, push the floppy disk drive bay toward

the front of the computer until it has fully engaged the slide brackets. There are two slides located on

either side of the 5.25-inch bay. All of these should be firmly seated when the 3.5-inch bay is installed

properly. (

see Figure 12: CDROM Removal on page 22).

4. Secure the bay with the screws on either side of the floppy disk drive.

5. Connect all cables for the drives located within the drive bay.

6. Reset the CUDA (

refer to CUDA Reset on page 4).

7. Install the front bezel (refer to Front Bezel Removal/Installation on page 8).

8. Install the side panel (refer to Chassis Cover Removal/Installation on page 6).