Specifications

CONFIDENTIAL

Removing the 3.5-inch Drive

1. Remove the chassis cover (refer to Chassis Cover Removal/Installation on page 6).

2. Remove the single screw that secures the drive cage to the back wall of the chassis. The cage will

swing up and out away from the computer.

Be careful of the wires for the drive that are still connected.

3. Disconnect the power cable and SCSI ribbon cable from any installed drives in the cage and

rotate the drive cage up and out of the chassis.

4. Remove the four mounting screws that secure the drive to the cage and slide the drive out.

Installing the 3.5-inch Drive

1. Slide the drive into the drive cage and line up the drive with the holes on the drive cage.

2. Replace the four screws that secure the drive to the drive cage.

3. Reconnect the power cable and SCSI ribbon cable for any installed drives in the cage.

3.5-inch Drive Removal/Installation

Figure 11:

Removing a 3.5-inch

internal drive bay

3.5-inch internal

drive bay

Drive Cage retaining

screw

5.25-inch Drive