Specifications

CONFIDENTIAL

Removing the PCI Riser Card

1. Remove the chassis cover (refer to Chassis Cover Removal/Installation on page 6).

2. Locate the riser card (refer to MLB Diagram on page 5).

3. Remove any installed PCI cards (refer to PCI Cards Removal/Installation on page 15).

4. Remove the hex-head screw that secures the support beam to the rear of the chassis.

5. Swing the rear end of beam slightly up and out of chassis. Pull the beam towards rear of machine

to remove.

6. Firmly grasp the PCI riser card and pull it straight out of the computer. Sometimes a gentle

rocking motion from end to end

(not side to side) will make it easier to remove the PCI card.

Installing the PCI Riser Card

1. Lower the PCI riser card squarely into the PCI slot so that the notch in the PCI card lines up with the

notch in the PCI slot. Slide the contacts straight into the PCI slot and make sure the contacts are firmly

seated. When properly seated, the contacts on the bottom should not be visible.

PCI Riser Card Removal/Installation

Figure 11:

PCI Riser Card Removal