Specifications

CONFIDENTIAL

Before you install any expansion cards, be sure that the combined power consumption of the

expansion cards does not exceed the limits of the computer. Refer to the documentation that

came with the cards you are installing for their power consumption rating and to ÒPower

requirementsÓ in the UserÕs Guide for the power consumption limit for this computer.

Removing PCI Cards

1. Remove the chassis cover (refer to Chassis Cover Removal/Installation on page 6).

2. Lay the computer on its side, open side up.

3. Remove the bottom panel of the chassis. Remove the two screws on the bottom panelÕs left side.

Slide the bottom panel straight up to remove it.

4. Disconnect any cables that may be attached to the PCI card.

5. Remove the screw attaching the PCI card to the inside of the chassis.

6. Firmly grasp the PCI card and pull it straight out of the computer laterally. Be careful not to

damage any components that may be protruding through the I/O slot. Sometimes a gentle

rocking motion from end to end

(not side to side) will make it easier to remove the PCI card.

Installing PCI Cards

1. Remove the chassis cover (refer to Chassis Cover Removal/Installation on page 6).

2. Lay the computer on its side, open side up.

3. Remove the bottom panel of the chassis. Remove the two screws on the bottom panelÕs left side.

Slide the bottom panel straight up to remove it.

4. Remove the retaining screw of the metal I/O slot cover from the slot you wish to use. (

see Figure

10: Removing PCI slot cover on page 16).

5. Pull the I/O slot cover out the side so that the tongue at the bottom of the cover slides out of the

slot in the chassis.

PCI Cards Removal/Installation