Specifications

CONFIDENTIAL

Removing the Cache

1. Remove the chassis cover. (refer to Chassis Cover Removal/Installation on page 6).

2. Locate the cache card (refer to MLB Diagram on page 5).

The level 2 cache is located between the CPU riser card and the front drive bay assembly. If you

believe that the area is too small to adequately grasp the cache card, remove the CPU riser before

removing the cache (refer to CPU Removal/Installation on page 12).

3. Place both hands on either side of the L2 cache card and lift up. Because the L2 cache is held in

by a tight pressure fit, sometimes a gentle rocking motion from end to end (not side to side)

will make it easier to remove the cache card.

Installing the Cache

1. Hold the L2 cache card (contacts facing down) with one hand at each end. Notice that there are

notches in the contact edge of the L2 cache card.

2. Lower the L2 cache card squarely into the slot so that the notches in the L2 cache card line up

with the notches in the slot. Slide the contacts straight into the slot and make sure the contacts

are firmly seated. When properly seated, the contacts on the bottom should not be visible.

DonÕt force the L2 cache card into the slot; if the MLB starts bending significantly, pull the L2

cache card out, reposition it, and try again.

4. Reset the CUDA (refer to CUDA Reset on page 4).

5. Replace the chassis cover (refer to Chassis Cover Removal/Installation on page 6).

Cache Removal/Installation

PCI Cards