Specifications

CONFIDENTIAL

the contact edge of the CPU card.

2. Lower the CPU card squarely into the slot so that the notch in the CPU card lines up with the

notch in the slot. Slide the contacts straight into the slot and make sure the contacts are firmly

seated. (

see Figure 9: CPU removal on page 12). When properly seated, the contacts on the bottom

should not be visible.

DonÕt force the CPU card into the slot; if the MLB starts bending significantly, pull the CPU card

out, reposition it, and try again.

3. Reset the CUDA (refer to CUDA Reset on page 4).

4. Replace the support beam. First, fit the forward end of the stabilizer bar into the two small cut-

outs in the front panel of the metal case. Then, swing the bar down, aligning it with the riser card

and the processor card.

5. 5. Replace the chassis cover (

refer to Chassis Cover Removal/Installation on page 6).

Cache