Specifications

CONFIDENTIAL

Removing the CPU

1. Remove the chassis cover (refer to Chassis Cover Removal/Installation on page 6).

1. Lay the machine on its side, open side up.

2. Remove the hex-head screw that secures the support beam to the rear of the chassis.

3. Swing the rear end of beam slightly up and out of chassis. Pull the beam towards rear of machine

to remove.

4. Place both hands on either side of the CPU card and lift up. Sometimes a gentle rocking motion

from end to end (not side to side) will make it easier to remove the CPU card.

Installing the CPU

1. Hold the CPU card (contacts facing down) with one hand at each end. Notice that there is a notch in

CPU Removal/Installation

Figure 9: CPU removal

CPU card

PCI Riser Card

Retaining screw