manual

POWER BOX Evolution 40/16
- 8 -
You can now move the two micro-DIP switches to the opposite end-point using a
small, pointed screwdriver. Caution: very little force is required for this, and you can
easily damage the switches if you use too coarse an instrument.
Now connect the batteries you wish to use to the PowerBox.
The PowerBox 40/16 Evolution is equipped with five stabilised two-way signal
amplifiers, i.e. a separate amplifier for each channel. In our opinion this additional
complexity is definitely worthwhile.
It completely eliminates the problem of “crosstalk” between the different channels,
which can occur when only one IC is used for this purpose. The signal amplitude is
maintained exactly at a constant 5.0 Volts: another feature which is only found in
our systems. Many servos do not respond correctly to signals which fluctuate in
voltage.
These modern, short circuit-protected signal amplifiers are also necessary in order
to block out interference which could penetrate the system via the servo leads
connected to the unit.
Naturally all our PowerBoxes are protected against reverse voltage which might be
generated by servo motors.