manual

POWER BOX Evolution 40/16
- 14 -
When the unit is switched off, the “Standby” circuit of the electronic switches
draws an idle current of around 5μA. This equates to a fraction of the self-discharge
rate of normal batteries.
The ribbon cable attached to the SensorSwitch should be plugged into the red
multi-pin socket on the right-hand side of the backer. Note that the switched state is
not affected if the SensorSwitch is accidentally disconnected or comes adrift for
any reason!
Please take the trouble to deploy the ribbon cable in such a way that it is not
subject to vibration!
Don’t just let it dangle in the fuselage, and don’t place it under any strain. A small
piece of double-sided foam tape between cable and fuselage is often all that is
required.