User manual PowerBox Professional

www.powerbox-systems.com 23
8. TELEMETRY
The PowerBox Cockpit, Competition and
Professional makes battery data available
as telemetry information which can be ex-
ploited by various makes of radio control
system. The unit supports the following
makes of equipment, and other systems
will gradually be introduced as updates become available:
- PowerBox CORE P²BUS
Connect the PowerBox telemetry output to the receiver’s P²BUS input using
a standard commercial Uni patch-lead. The voltage and residual capacity
data are now available at the transmitter.
- Jeti
Connect the PowerBox telemetry output to the receiver’s EXT input using a
standard commercial Uni patch-lead. The voltage and residual capacity data
are now available at the transmitter.
- Futaba
Connect the PowerBox telemetry output to the receiver’s sensor input using
the Teleconverter (Order No. 5600). The voltage and residual capacity of
both batteries are now available at the transmitter.
- Multiplex MSB
Connect the PowerBox telemetry output to the receiver’s sensor input using
a standard commercial Uni patch-lead. The voltage and residual capacity of
both batteries are now available at the transmitter.
- Spektrum
Connect the four-pin Spektrum Telemetry output to the TM1000, and at the
same time bind the TM1000 and the connected satellites to the transmitter.
Activate the PowerBox Telemetry display at your transmitter. The voltage
and residual capacity of both batteries are now available at the transmitter.
The matching X-Bus lead for this can be obtained in various lengths from
Horizon Hobby:
SPMA9579 X-Bus extension 150 mm
SPMA9580 X-Bus extension 300 mm
SPMA9581 X-Bus extension 600 mm