User manual PowerBox Professional
www.powerbox-systems.com 19
In spite of the vast scope of these facilities, the sequencer is simple and
user-friendly to set up, as the screen and menu system guide you through the
procedure. The sequencer software also features supplementary program-
ming aids. Once you understand the principle, the system can easily be pro-
grammed without recourse to the manual.
We always recommend that you start the setup procedure using the Setup
ASSISTANT. This incremental setup aid creates the tasks required, automati-
cally detects the retract switch channel, and assigns the transmitter channel
for the gear switch. If you use the Assistant, but nd it necessary or desirable
to alter the settings subsequently – perhaps to ne-tune the timing – then
this can be carried out using the menu points outlined below. To help you
arrive quickly at a satisfactory result, the following section lists the door se-
quencer functions in detail:
The primary component of the procedure is the TASK, which is self-expla-
natory: a task refers to the movement of a servo from its starting point to its
stop point with a dened start and stop time. Twelve tasks are available for
the retraction process, and a further twelve for extension. In total 24 different
movement sequences can be programmed.
A TASK contains the following information:
Value Range
Task number 1 – 12
Extend or retract undercarriage UP » DOWN / DOWN » UP
Servo number 1 – 6
Servo START position
700 µs – 2300 µs700 µs – 2300 µs
Servo STOP position
700 µs – 2300 µs700 µs – 2300 µs
Start time 0 – 25.0 s
Stop time 0 – 25.0 s