Instruction Manual

18 PowerBox-Systems − World Leaders in RC Power Supply Systems
10. CALIBRATING THE TRANSMITTER CONTROLS
Naturally the PowerBox CORE is supplied with all func-
tions correctly calibrated. However, if you wish to swap
a switch or replace a broken switch, we recommend
that you re-calibrate the new switch. Re-calibration is
also necessary if, for example, you limit the throttle stick
travel, or change the transmitter mode mechanically.
Move to the Calibration menu by this route: Settings 
System  Calibration. Move the transmitter control you
wish to calibrate in order to select it. The information
relating to this transmitter control is now superimposed
on the right.
For example, if you wish to change from a 3-position switch to a 2-position switch, select the appropriate switch
type in the Type eld. Once you have done this, touch Calibration at the bottom, then move the control to both
end-points. The Continue eld now appears. If you have installed a proportional control or a 3-position switch,
you also need to move the transmitter control to the centre. Touch Finished to complete the process.
The Direct button can be used to reverse the transmitter control’s direction of operation.
Caution: this has the same effect as installing the switch the other way round, i.e. this change affects all
models!
11. SPECIFICATION
Power supply Li-Ion
Channels 26
Servo signal resolution 4096 Bit
Screen TFT - Touch
Weight Handheld version: 1190g
Tray version: 1330g
Temperature range -30°C to +85°C
12. SET CONTENTS
- PowerBox CORE
- 1x PBR-9D
- 2x PBR-8E (limited Early bird edition only)
- Case
- padded neck strap
- main adapter
- conversion tool
- sticker set
- screen cleaning cloth
- exclusive Shirt „CORE“, navy
- Instruction manual in german and english