Instruction Manual

www.powerbox-systems.com
17
c) Adjusting the tension of the primary stick centring springs
The centring spring tension can be adjusted using screws 1 and 2 after loosening the corresponding locknuts.
Tightening the screw further increases the spring tension. If you nd it impossible to set your preferred spring
tension, we can supply a range of stronger springs.
d) Adjusting the throttle ratchet and brake
The hardness of the throttle ratchet can be adjusted using screw 3. Screw 4 adjusts the friction brake.
e) Adjusting the throttle travel
The travel of the throttle stick on the CORE is adjustable. This is useful for 3D pilots in particular, as it enables
them to set a mechanical limit on throttle travel. Adjustment is carried out by tightening screws 5. The throttle
travel can also be set up asymmetrically. Once you have set the travel of the throttle stick to meet your require-
ments, it is essential to re-calibrate that function.
f) Switching modes
As already mentioned, the software has no modes, but naturally the hardware must correspond to your preferred
mode.
If you wish to change the factory default mode, rst undo screws 6 from the ratchet plate, then install the ratchet
plate on the other primary stick unit, as an exact mirror-image of the original installation. Tighten the retaining
screws, pressing the plate towards the centre of the transmitter.
The next step is to re-install the spring blocker (8): remove screw 7. The screw with the locknut can immediately
be installed again on the other side.
To re-install the spring blocker, move the stick fully to its end-point, t the spring blocker pin under the spring lever,
then tighten the spring blocker screw.
Note: if you tighten the screw too far, you may nd that the lower spring tensioner partially moves out of its
guide. You can correct this by moving the stick fully to one side, at the same time pressing the spring tensio-
ner back into its guide using a small screwdriver.
6
5
4 3
1
2 / 7
8