Instruction Manual
16 PowerBox-Systems − World Leaders in RC Power Supply Systems
b) Opening the transmitter
As standard the CORE is supplied in the correct mode, as specied by the customer, but some users may nd
that the centring spring tension or the ratchet function needs to be adjusted to meet their personal preferences.
The rst step is to remove the handrests. Lay the CORE on a soft surface – ideally a thick layer of foam. Now
undo and remove all ten socket-head screws holding the back cover. Don’t remove the back cover yet, as the
cables for the switches and proportional controls in the cover must rst be disconnected.
This is the procedure: raise one side of the back cover slightly, and loosen the connectors by moving them to left
and right whilst pulling gently, then repeat the process on the other side.
The back cover is now free, and can be lifted off. You will see the transmitter’s internal features: