user manual

8 PowerBox-Systems − World Leaders in RC Power Supply Systems
- Jeti EX
The SparkSwitch PRO must be set to use the Jeti telemetry system. This can be
accomplished using the Terminal program or the Jeti USB adapter.
Connect the SparkSwitch RX input to the receiver’s switch channel. The receiver’s
Telemetry input must be set to JETI BOX. Connect the Telemetry output from the
SparkSwitch to the receiver’s Telemetry input using the second patch lead.
The telemetry data are displayed in the transmitter’s Sensor menu.
- Futaba S.BUS 2
Once you have selected the Futaba telemetry system, you must connect the Futaba
receiver’s S.BUS 2 output to the DATA input of the SparkSwitch. This enables the
transmission of servo and telemetry data. The default switch input is channel 12.
You will nd a detailed, illustrated description of the procedure for setting up a
Futaba transmitter for telemetry data in our PowerBox Support Forum.
- Graupner Hott
The SparkSwitch PRO must be set to the Graupner telemetry system.
Connect the RX input on the SparkSwitch to the receiver’s switch channel, then
connect the Telemetry output on the SparkSwitch to the receiver’s Telemetry input
using the second patch lead.
The telemetry data are displayed on the transmitter as Engine Modules.
- Multiplex M-Link
The SparkSwitch PRO must be set to the Multiplex telemetry system using either
the Terminal program or the Multiplex USB adapter.
Connect the RX input on the SparkSwitch to the receiver’s switch channel, then
connect the Telemetry output on the SparkSwitch to the receiver’s Telemetry input
using the second patch lead.
The telemetry addresses can be set using the Terminal program.