user manual

4 PowerBox-Systems − World Leaders in RC Power Supply Systems
3. FIRST STEPS BEFORE USING THE UNIT
3.1. CONNECTING
Complete all the electrical connections as shown in the wiring diagram above. The
battery should be connected last.
For safety reasons the external LED must always be connected. It should be instal-
led in such a position that the external LED is clearly visible to the pilot at all times
when the engine is being started.
Caution: If the external LED is not installed, the pilot has no way of knowing
whether the ignition is switched on or off. This involves unnecessary danger!
3.2. INSTALLED POSITION
Install the SparkSwitch PRO close to the ignition unit. Do not run the ignition power
supply cables close to other wiring which is connected to the receiver.
3.3. SETTING THE TELEMETRY SYSTEM
Connect the PowerBox USB interface adapter or BlueCom adapter to the socket
on the ignition switch marked DATA. A battery (max. voltage 8.4 V) must also be
connected to the receiver socket. Run the PowerBox Terminal program on your
PC, or the Mobile Terminal App on your smartphone, then follow the on-screen
instructions.