User manual PowerBox Competition SR2

www.powerbox-systems.com 5

1.INITIAL INSTALLATION: GENERAL SEQUENCE OF OPERATIONS

When installing the unit it is important to keep to the standard sequence described

below, and adhere to the subsequent setup stages, as this ensures that your instal-

lation of the Competition SR2 will be swift and problem-free. The individual points

are explained in full in the remainder of these instructions:

- Mounting the PowerBox, switch and screen

- Connecting the receiver and batteries

- Settings in the General Settings menu

- Setting up all the functions at the transmitter

- Carrying out the Setup Assistant

- Carrying out the Door Sequencer Assistant

- Assigning all remaining functions in Output Mapping

- Setting up all control surface travels, ight modes, Dual-Rate, Expo etc. at the

transmitter

- Using Servo Matching to equalise servos operating in parallel

- Learning the stick end-points in the iGyro menu

- iGyro set-up ight

- Fine-tuning the iGyro

not required if wheel doors are not present

not required without a gyro

2. INSTALLATION, CONNECTIONS

a) Mounting

The Competition SR2 should be mounted in the model on a robust sub-struc-

ture using the four screws, rubber grommets and brass eyelets supplied in the

set. The installed location is not important, but if an iGyroSAT is to be used, the

sensor must be installed perpendicular to the model’s centreline. Ideally the TFT

screen should be in a clearly visible location. The very bright screen lighting ma-

kes it easy to read even in full sunshine, so no special provisions have to be made

here. The screen is connected to the socket marked Display on the side of the

PowerBox.