User manual PowerBox Competition SR2
www.powerbox-systems.com 29
This means: you should move all channels to the desired position at the transmit-
ter before you set an output to Failsafe.
The usual way to check the setting is to move the throttle channel to the half-way
point, then switch the transmitter off: the throttle servo must now immediately
move to the Idle position.
If you are using a CORE system, the Failsafe settings are adopted from the trans-
mitter; this overwrites any Failsafe settings which you select at the PowerBox
Competition SR2.
10. INPUT MAPPING
The Input Mapping menu is used to assign the channels coming from
the transmitter to functions such as Gyro, Sequencer or capacity reset.
The assignment process is carried out by the Setup Assistant and the
Sequencer Assistant. If you add functions later, or change channels at
the transmitter, it is possible to make appropriate adjustments subse-
quently at any time.
In particular, assigning different Gain channels for the iGyro makes it easier to enter
the settings for more complex applications.
The screenshots above show once more that the Setup Assistant determines the
function designations. On the left we see the general function names, whereas on
the right - after carrying out the Assistant - the names are specic to your model.
These pictures also clearly show the separate Gain channels for each gyro function.