User manual PowerBox Competition SR2

www.powerbox-systems.com 13
On the other hand it is possible to retro-t an iGyroSAT without having to re-pro-
gram the battery backer. All assignments are already complete, and even the servo
matching is maintained.
Before you select the Setup Assistant, establish all the primary functions at the
transmitter, ideally with 50% travel. Mixers such as delta, tailerons and thrust vector
must also be programmed at the transmitter before you start. Check the functions
using your transmitter’s servo monitor. At this stage servo centre positions and di-
rections of rotation do not matter.
If you also intend to use an iGyroSAT, you should now install the gyro sensor in
a suitable position, perpendicular to the fuselage centreline, and connect it to the
socket marked FastTrack on the Competition SR2. If you are also using a GPS III as
telemetry sensor (and for gyro speed compensation), this should also be connected
to the FastTrack input using a Y-lead.
Select the Assistant widget in the Main Menu, and you will see the following dis-
plays:
In the rst display you select the wing type (Normal / Delta) and the tail type
(Normal, Tailerons or V-tail). You can also determine whether the model has a thrust
vector system (Single or Dual).
Note: When setting up the PowerBox Competition SR2 for the rst time, please
keep to this sequence:
Setup Assistant (basic setup) –> Sequencer Assistant –> manual output
assignment of all other functions.