User manual PowerBox Mercury SRS with OLDED Screen and GPS

www.powerbox-systems.com 9
correct axis. Hold the model’s tail at a slight angle, so that the bar deects fully to
the right, and wait until the elevator jumps back to the neutral position. The screen
now switches automatically to the next display.
2. At this point you are requested to swing the model’s tail to left or right: the rudder
should immediately deect in response to this movement. Here again: if the rudder
does not respond, briey jerk the model’s tail once to left or right, so that the sensor
switches to the correct axis.
Now hold the model’s tail far enough to left or right to cause the bar to move to full
deection, and wait until the rudder jumps back to the neutral position. This conclu-
des the procedure, and the following screen display appears:
You can install the Mercury SRS in any position, provided that the case is at right-
angles (90°) to the fuselage centreline.
5.2. Model type
The next step is to select the model type which is the closest match to your aircraft.
The main effect of your choice at this point is the assignment of the outputs. Take a
look at the table below and decide which output assignment suits your model best:
Note: it is also possible to change the output assignment at any time.