User manual PowerBox Mercury SRS with OLDED Screen and GPS
8
PowerBox-Systems − World Leaders in RC Power Supply Systems
4.3. Battery type
The battery type you wish to use is also determined in the GENERAL SETTINGS menu.
This setting is important, otherwise the battery display will not be correct.
4.4. Output voltage
This is where you set your preferred output voltage: the available options are a regula-
ted output voltage of either 5.9V or 7.4V. If you intend to use the 7.4V option, please
ensure that all servos, switches and valves connected to the system are HV types, as
the voltage is the same at all outputs.
5. SETUP ASSISTENT
Once the basic settings are complete, you can move on immediately to the Setup
Assistant, which can be found on the second page of the main menu.
Start the Setup Assistant and follow the instructions on the screen. When you have
concluded the settings on each screen display, press the SET button twice to move on
to the next step. A single press of the SET button allows you to select BACK and return
to the previous screen.
5.1. Installed position
You will nd the following screen displays in the SETUP ASSISTANT and also in the
GENERAL SETTINGS menu under SET ORIENTATION:
1. At the rst screen you are requested to raise or lower the model’s tail. You can im-
mediately determine whether the correct axis is selected by observing the elevator’s
response. If the elevator does not deect, briey jerk the model’s tail up or down
once. The PowerBox detects this movement, causing the sensor to switch to the